How the heck did you mark and drill the holes by the firewall? I don't have a drill or right-angle small enough to fit in there from the outside, and from the inside I can't tell exactly where the holes should be. Towards the end of your video it looks like you may not have drilled the holes yet, I don't see bolt heads over there... For the record, I'm throwing away the evil horrible nutserts and going with extra washers and nylock nuts. You can get to the back of everything if you install the smaller panel first and tighten up those firewall-side bolts. Well, I could if I could figure out how to drill the holes...
@@ozguy1393 Really nutserts only make sense with a good quality tool. We have enough Jeeps I broke down and bought one. Overall I think Artec is good, those couple extra mounting points aren't that important.
Rough videography due to experience still being builtup by OP but at least he documented & published the process. That redeems the dialogue . Thanks for capturing then sharing. 👍🏻
Are all of those nutserts used. It doesn't look like you need all of them? Wish you would of showed how to use the nutserts tool. How much do you have to tighten them?