To change the set temperature, press the button a second time before the LCD stops flashing. Each press of the “Cool” or “Warm” button will continue to either lower or raise the set temperature respectively.
Enter Programming mode by holding the Light key down for 5 sec. The hour will start flashing. Use Up or Down arrows to change hour setting, passing the 12 o’clock hour to set the AM/PM. Once the correct hour is selected, then press the Light key to set. Then the minutes will start flashing. Use Up or Down arrows to change minutes. Once the correct minutes is selected, then press the Light key to set. I hope that helps. :-)
I have this same control panel. The temperature down arrow does not work. The Panel works fine otherwise. the unit is a 2019. My dealer offered no advice on diagnosis or potential issues. Do you have any suggestions before I drop $200 plus on a new panel. I did restart unit. Thank you and thanks for the content.
Did you pull the battery 🪫 out and restart it that way? If so my only other suggestion would be to replace. Sorry to hear that. It is the first time I have heard of this issue…. Thanks for watching!!
@@TheHotTubLady ! Thank you, I would have not guessed it had a battery. Do you sell these control panels ? id rather buy it form a helpful dealership like yours.
@@jklo1313 I’m sorry. I thought this was the hot spring control pannel video. You will probably need to replace it. I’ll check with the parts department
My spa keeps switching to economy mode on its own. We keep going out to get in the spa and it’s down to 60 degrees. We put it on standard mode, come back out another day, and it’s back on economy mode again
@@kimberlyshandy4619 www.worldofhottubs.com/wp-content/uploads/2016/08/2015-Artesian-Spas-South-Seas-Spas-OwnersManual.pdf it it is a 2015 this should work Page 18-19 will have the answers your are looking for.
I am trying to control when the tidalfit spa heats up as we have cheap electricity at night. The “not heat up” controls don’t seem to work. We have had a new control panel fitted but I am concerned that we are just not doing something right with the setting.
My advice is not to do that. As your hot tub will coat you more to hear it back up 6 degrees then it would To Maintain it at 101. It is better to maintain then to constantly be turning ot up and down. You electric bill will be less Ana your equipment will Last longer
Are the lights able to fade through the colors? I’ve seen these go through the different colors at night and have to say the complete darkness between color changes is like a slow strobe light.
You can either set the light on one specific color or have it change when it changes it does shut completely off before it goes to the next color. Unfortunately this tub doesn’t have the ability to smoothly transition.
@@reelnickfishing5117 so the heater is connected to the dual speed pump. You had to wire that 50 amp 220 correct? You wouldn’t be able to have both pumps running the heat.
@@TheHotTubLady yes instructions show 50amp, however was told if I use 60 amp service I can enable so heater can operate while both pumps are on. so trying to figure out if I upgrade the service how I can enable this. Will just work when it sees 60 amp service. thanks for all your help really appreciate it.