No video :(

ASME PTC 19.3 Thermowell Calculation of Taper Ratio

Подписаться 14 тыс.

Просмотров 5 тыс.

50% 1

Thermowell can be tapered or straight .
This criteria is defined in ASME PTC 19.3 Which defines the taper ratio and the limits that we can use for taper ratio calculation.
the criteria is to keep the taper ratio between 0.58 to 1.
Also, You can download the FREE E-book on PIP engineering standards from the link below
www.asad-shaik...

Опубликовано:

23 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 18

@AsadPassionateEngineer Год назад

🔴Thanks for watching and if you have liked the Video then you can check out my Master Class on 👉 UDEMY I am highly positive that you would find the Master Class super valuable. Link to Udemy Masterclass : www.udemy.com/course/how-to-read-pids-piping-instrumentation-diagrams-symbols/?couponCode=LOWESTPRICE389 My best wishes for your success, Keep learning and keep growing in your career !!! ✔

@rikgto9351 6 месяцев назад

Thanks Asad, what is the software used to do the calculations? I understand a damaged Thermowell can damage equipment downstream as well as, understandably other major issues

@informationproject9499 2 года назад

Superb information.. thanks...I have questions about thermowell ..how to select stright, tappered,step type and shap size and insertions lenth .any more calculation in thermowell.??? Interviewers akses calculetion of thermowell.

@ahmedsaidi8852 2 года назад

Thanks à lot asad

@AsadPassionateEngineer 2 года назад

Most welcome ☺️

@ankurbhatnagar4459 2 года назад

Nice Asad..

@AsadPassionateEngineer 2 года назад

Thank you so much @Ankur 😊

@pavanmamtora902 2 года назад

Thanks Asad for video. Can you explain where should we consider straight or tapered thermowell?

@AsadPassionateEngineer 2 года назад

Most welcome 😃. Good question !! One of the basis to decide this is the client Design basis. However, in our industry the most widely used thermowell is tapered TWs. Like a similar example is that of thermowell connection, usually we have flanged thermowell but for certain special cases we could go for welded design but this depends on client preference. This is as per best of my current understanding. Hope some engineers can shed more light on to this subject 🙂