Atlas RS1 DCC install 

Thanks. A thing of beauty. I started looking at these trains (N scale) as a curiosity, now I have a box of engines, cars, flex tracks, tools, parts, a controller... Get the picture? There is no going back.

Thanks Larry! Yet another very fine installation! I do enjoy your videos and insights!!!

I placed a TCS KA3 keep alive in the cab. It’s possible to get those things in there! Great job

very well explained and demonstrated. Thanks

Thanks for sharing. Great video.

Hey there. Could you tell me what decoader you used. I have two of these engines. Thank you. Rick.

NICE JOB Larry. I always learn a lot from your installations. However I do have a question. You wired your speakers in series rather than parallel. Would it not be better to hook them up in parallel and have 4 ohms rather than 16 with a series hookup? Isn’t it better for the decoder and the speakers to wire with the smaller ohm draw? This has always confused me and is a major reason why I only install a single speaker. Once again, thanks for the video.

Just an FYI they do make 21 pin motherboards that have a built-in keep alive. Maybe one of them would have fit?

Hey Larry. Those tsunami s are getting really good at ss 1, now. Every bit as good as ESU. Was that the tsunami 2?. Nice job. Thanks... Michael NZ

Ok but why a decoder buddy and 21 pin decoder? Wouldn't a PNP/direct style board make more sense?

Hi, what model or part number are the Sound Systems Speakers that you installed?

I use iP 4 speakers