Audi backup camera replacement. Retrofit on Audi A6 c7 

Check this video out ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-HwfjcGh935Q.html Black goes to ground

Those quick splice wire connectors are super cheap

Code?

Hi Abu, it’s kind of difficult but I would suggest you go to an Audi workshop and asked them how to remove the side panels below or above the doors. There are a few ways to do it either above or below the doors. The critical point is the passage through the “arm” of the trunk into the actual trunk. Since it’s a moving part you want to lead the cable through the rubber hose with the rest of the cables. I will try find a video that shows that otherwise you might convince one of the guys in the Audi garage to do it for some money “on the side”.

Some hints www.audiworld.com/forums/a4-b5-platform-discussion-1/easiest-way-run-wires-head-unit-trunk-144800/

ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-k08g1mqNX9g.html Shows the same principle

@@mr_fix . Thanks a lot , really appreciate 😎

Hi again, I can see you have a matrix taillights as mine. Just asking what’s the color of the reverse light cable? And secondly did you have to wire the camera with a relay..I have 2017 A6 with RMC unit..do you live in Sweden ? Cause the environment looks as such..thanks

Thanks! :-)

Have a picture on where it’s connected if you want, where can I send it?

@@mr_fix halo. Yes, please if you can on my e-mail - stanio38ela@gmail.com

I hope the picture I sent helped?

@@mr_fix Thanks. I sent e-mail to you.😉

I hope you received my email. The yellow cable connected to the CarPlay device should connect to the yellow connection for the backup camera (the other yellow one connected to the CarPlay device is for a front camera). if I remember correctly the short red cable connected to the yellow connection should be connected to something named camera/rear/reverse or something like that coming from the CarPlay device and will only give power when you put the car in reverse. On the camera side you connect yellow cable to yellow cable on the camera and the red tiny cable (connected to the yellow one) to the red wire coming from the black connection. The thin black cable coming from the black connection should be connected to ground like in the picture I sent you. Good luck!

Check this site! A camera is not enough. youtube.com/@uniqueautodevelopments

Sorry, I don’t know

I know :-). After unscrewing the 4 screws you have to use quite a lot of force to pull the cover loose. Those clips are sturdy :-)

Yes retrofit usually is :-)

But I must say it works really really well even though it’s cheap