Is there a way to tell by the dl501 adaptation values if it is wearing at a high rate? Like the zf 6 speed could tell you how far from stock they have moved to adapt to aging.
Hi Svarog Performance I have same transmission but my is stucked in error P287B00, i tried several diagnostic tool to reset but it is still stucked. Can you give me some hint on this problem Thank you
P286B Clutch contact pressure too high. P17D7 Electric pressure actuator 5 Monitoring circuitry - Electricity too high P17D6 Electric pressure actuator 4 Monitoring circuitry - Electricity too high Greetings from Germany 🇩🇪
VCDS software is free but you have to buy the adapter cable as it acts as a key to allow you to use the software. you have to order cable from Rosstech website. there are two options, the cheaper is about $500 and allow you to use VCDS on up to 3 cars and the full version allows you to use it on unlimited number of cars but costs like $1500-2000
Absolutely yes ! You have to do actually first time when heat cycle at the first start on new clutch after 1 hour then drive the car 100 miles do it again / than drive car for 500 miles do it again / then launch the car 5 times and do it adaptation again and after this, perform others at every oil change to be just make sure it’s all good
Hey Bud, I'm doing the mechatronics repair kit, which is just the wiring harness. Do i need to do this adaptation after? I think I need to do adaptation when changing the solenoids but not the repair kit harness? Also, will doing this delete my TCU tune? thx
How much did it cost to install the upgraded clutches? At what point do you think they need to be upgraded as far as the power at different stages (using apr as the example)
Labor around $2K+ If you having issue and clutch slips then yes I would recommend do performance clutches but OEM Clutch Pack should be good for 550WTQ
@@drancyneuftrois3120 I got Vcds, good for OAM’s but I prefer Autel has 5 steps all up compared to vcds 3 things to do, I do probably 1 a fortnight down here in Australia were we don’t get much access to TsB’s an genuine info, what’s ur car doing after work has been carried out? Leaving any codes ?
Hi! I have 2009 Audi S4 (0B5 DL501) after i replacement the clutch plates and mechatronic repair kit, I have big slam and jerky when i take R or D while i standing. I do adaptation but i dont take test drive beacuse i dont know is it normal to jerk or no. I just need to go 100-200 kilometer and it will be good? Thank you!
@@Imabaitr6 You can try but sounds like you have some hardware issues with the pressure control could be a bad Solinoid or board etc.. Would recommend doing a full rebuild and cleanecharronic unit
