Audi RS5 B9.5 - Center Console Trim Replacement 

This is a tremendously helpful video. Thank you so much! A couple of observations for anybody else attempting: (1) As JonathanU said, do not try and pry off the black trim piece without taking off the plastic undertray to which it is attached. The reason is because not only is the trim attached by clips but also by screws. It is impossible to remove the trim otherwise! (2) The undertray attaches to the center console through six metal clips. When you pry off that piece most if not all of the clips will likely fall off the plastic tabs they are attached to. On the left side middle, that clip may be stuck inside the connection hole. To get it out just pull out the side trim facing the driver's right leg (left hand drive) and use a small screwdriver to push it out. Reattach all six clips to the long plastic tabs and you should be good to go.

Great video! The B9 SQ5 console is extremely similar to this, so your video helped me be sure I was pulling on the correct things in the correct spots when doing my 2023 SQ5.

Got my dad one for Father’s Day, thanks for the video

Great video. This is a 30-45 min job.

Thanks for this video! I've been looking for a source to help me remove the black glossy piece so I can wrap it in matte carbon fiber

Great video man. Thanks for doing this. Installing mine this weekend.

do you know if the B9 trim piece is the same as B9.5, I have 2023 b9.5 but would like to put a non shiny piece from a B9?

Thanks for the video, really helpful !

Where you get Alcantara shift knob?

I have a '22 S5 Cabriolet. I ordered the trim piece a long time ago but it has just been sitting around. On the Cabriolet, the little pocket that you lift up the rubber mat from to access the very first screw you remove, is not there. Instead that is where the controls for the convertible top are located. I cannot find any information on how to go about removing those controls so that I can remove the rest of the console and install the new trim. Any suggestions?

Where did you find this carbon trim piece?

It says out of stock.

I dunno, although the piano black is a pain to keep clean and in good shape, going with carbon fiber has too little contrast imo. I think a satin finish black or maybe some fine black woodgrain would be a bit more elegant looking. I do like the carbon fiber in the stock interior but it needs to be broken up.