Avata 2 Full Power Unlock | FCC Hack / Mod | Speed, Response Comparison | Direct 

OMG, thank You so much

Ohh, sweet. I need to do more tests then xD

Yes, I did update the firmware. And it still works.

Haha, I knew people will find it helpful !! thx!

keep in most likely, im gonna assume removing it makes the goggles not read the ham file and thus default to original DJI settings

You don't have to keep SD Card with HAM file always inside. Googles remember this "hack". Only way to disable this is to hard reset googles

You dont need to keep it. As a matter of fact I put it in and turned on the goggles just to realize I didnt recorded the pre-hack CE flight. So I turned the goggles off without launching the drone, took the SD card out and then repowered goggles, drone and controller again.. aaaand the FCC hack was online (I hoped it was not), I already felt the power change. But for video coherence I didnt included this in-between footage. SO I had to reset my goggles there on the bench to get rid of the hack and do the CE flight correctly. Sorry for the confusion, I hope it makes sense.

I think you need to do it after each firmware update. I think it will be good to have small sd card staying in goggles with ham file or don't forget to check that mode after each update

It you first start up the drone, then controller, then goggles, it will be CE mode. First Googles means FCC mod. No need to hard reset

Would love to know that too!

No, motion controller speeds are the same in ce and fcc

Who the f cares

Just a empty file

format the sd card first.. and dont update

@@appslagu4704 thanks for the reply. I have the v01.00.0200 on the drone. Do you mean i should have not updated to this or after that?

How did you get it to fly this fast?

@@skylarblanton9677 ATTI mode

No, I'm not xD

no

CE is restricting the output power just in the manual mode. Any other mode (normal, sport) regardless of the controller, are the same speed in FCC as well as in CE.

@oscr_zen another question, so in manual mode, is it faster can go 40..50 60mph, that I see in you tube flying with there avata2, so I have to create ham_cfg_support in sd card using manual mode in remote controller so it can go faster more than 40mph, thanks

@@sweetmosquite as I am showing in the video, get the ham file onto a card and put it inside the goggles, you'll notice if its working on the remote controller when the throttle power is substantially raised

When I create a ham-cfg_support in notepad when I put this in the sdcard, I have a videos in there now..is the sd card need to be empty no files in there at all before I put this, thanks