I did not add engine oil when I reinstalled my fuel injector rails and it took a lot of effort which broken two of the o-rings causing air / fuel leaks. Thanks for that tip!
Great information! In this short vid You answered all the questions i had about the o rings on my motorcycle fuel injectors. Now replacing the rings. Thank you for this and all the info You pass on to us.
Excellent video! Clear and to the point! I've been chasing down a high idle on my car and discovered spraying carb cleaner at a couple of my injectors causes the idle to drop. I assume the o-rings are bad and causing a vacuum leak. I also noticed my car has trouble starting when warm and this might be why... the fuel pressure might be bleeding off when it's sitting. Thanks for the tips!
Thanks - had this problem on my 07 Kia with 200K kms - symptoms were random misfires on cold starts over winter (due to lean condition) and gas smell after parking in a garage in summer (due to escaping fuel vapours) - I diagnosed the vacuum leaks on the engine-side o-rings by spraying carb cleaner on the injectors while running the engine and listening for rpm change - when I pulled the injectors the engine-side o-rings were brittle and tore on removal while the fuel rail side o-rings were still pliable - heat was clearly a factor - to add, you can check for fuel pressure drop using a gauge to tell if the fuel rail side o-rings are leaking - engine should hold fuel pressure for min 5 mins after switching off
Great video as always thank you I did not know if you’ll injector O-rings or replaceable I will definitely replace mine this weekend on my two cars thank you
Good video! I have a question about the MAP sensor on my 04 Cavalier. I was told if it's weak it will cause the idle speed to be affected causing low idle bad gas mileage and not shifting properly is that true? I've already cleaned the throttle body. The car has over two hundred thousand miles on it. Any help would be great
Hey there brother I really need your help. My car is suddenly accelerating on its own and it seems like everytime it do so I couldn't press the brake all the way. This happens while the AC is turned on. Please reply 🙏
I’ve been fighting for weeks replacing everything in my fuel system on my Skyline R32, changed fuel pump, in-line filter, even the fuel pressure regulator, turns out it’s leaking fuel from one of the injectors, car kept dropping fuel pressure at idle and finally found culprit
is it safe to use ATP Automotive AT-205 Re-Seal Stops Leaks on new o-rings prior to putting them on. I have used AT205 to replenish old rubber before. Not o-rings but other types of rubber.
Bro, I need a little help here. I replaced drive shafts for a 2014 corolla today, and afterwards the gear hits really hard when I select to drive or reverse, and later on the the transmission isn't changing at all . What could be the case please ? Really need your help
Make sure the axle is pushed all the way in the transmission and also check transmission fluid. Transmission fluid can leak out when changing the axle.