I just got my bambu p1s with ams, and so far ive only used the basic bambu filament. Ive tried a couple intense prints with stock and default settings, auto supports, and a couple of times ive gotten spaghetti everywhere. Could this be a filament issue or something else? Ive also had some prints kind of melt more and sag (and ive noticed leaving my chamber door open helps with that) would you say there are other filaments that hold up better than the stock bambu? Or is it just more of a cost thing?
Not completely, I certainly had less failures after ensuring there was a clean bed but there were still failures that occurred. At this point, I'm holding off on using more Elegoo filament. Sometimes it worked perfectly fine, but then I'd print the same thing and it would fail. For now, I'm sticking with Overture filament.
