Barnes Truss On A Dana 44 Part-1

Подписаться 1,1 тыс.

Просмотров 1,3 тыс.

50% 1

Lots of prepping and fitting of the nine pieces that make up the Barnes Truss. Pieces were tacked and TIG welded in place. Part-1 follows the process just short of the final step which is attachment to the axle tubes.

Опубликовано:

4 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@JK_Joyride Год назад

Beautiful welds! Nice work by Nate. Top rate!

@reconjeeper0321 Год назад

Thank you Ren… he’s a top shelf guy … gotta get him out on one of our wheeling trips and meet everybody!👍🏻🇺🇸

@danabryan5358 Год назад

WOW!!! Your friend has an amazing talent- incredible job!! Lots of welding for sure - you must be thrilled!!

@reconjeeper0321 Год назад

Hello Dana.. it’s getting there for sure! One more trip! 👍🏻🇺🇸

@zaetke87 8 месяцев назад

Is it just me or was that factory track bar bracket weld cracking?

@reconjeeper0321 8 месяцев назад

Yes… last video shows it being replaced with a 1/4 inch Barnes… Good eye!👍🏻🇺🇸

@marcoss4563 16 дней назад

thanks for the videos, quick newbie question, how much amps did you put on it ?

@reconjeeper0321 16 дней назад

My friend Nate is the welder… TIG was used… not sure how many amps…👍🏻🇺🇸

@peetky8645 Год назад

what putty did you use to protect the threads from weld spatter?

@reconjeeper0321 Год назад

Hi… I used electrical duct seal. Worked pretty good… then used plastic brush to wipe out. Good luck

@peetky8645 Год назад

@@reconjeeper0321 thank you, good to know