Bissell Vacuum Cleaner Debris Removal & Suction not working 

Good point. I should have showed this. Yes just take a flat blade screwdriver or needle nose pliers. That debris actually comes out fairly easy. I would not recommend taking the brush out as you can reach it easily. It usually is clogged but not packed very tightly.

@@jbrummitt I did this with My vaccum but it's still no picking up good and there's no blockage

Hi JaQuay. Is it the same exact model as this one? The 2191? You pressed the power switch firmly? Check and make sure all the filters are seated in position.

The belt is Part Number 3031120. According to the Bissell website, this vacuum is a Powerforce® Helix™ Bagless Upright Vacuum, Bissell Model 2191 Similar Models: 2191U, 2191X. It works with 100 products. You can find the exact belt on their website. It appears to be around $7.

Hello. Usually the belt has just enough tension to hold the large brush roller in position. You can follow my video to get the bottom plate off and then grab the large brush roller and stretch it a bit to pull it out of its slot. Then it slips off the motor easily. Place the new one on the motor first and then around the brush roller and set everything back in position.

Sorry I have never done that before. Just what was shown here.

Yes, the belt is easy to change. The brush roller slides straight out, place the new belt around it and then on the motor. Slightly pull on the belt until the brush roller slides back in the slots. The belt should be on the motor and on the brush roller.

The blockage is usually soft material. Use needle nose pliers and pull out the clog. It is usually a very quick process. In most cases you can easily pull it out or break up the debris and pull out in small pieces with the needle nose pliers. Then, turn the vacuum upright, turn on the vacuum to see if the clog was completely removed.