BMW F650 Funduro Problem with Carb.

Подписаться 92

Просмотров 16 тыс.

50% 1

I had nothing but problems with my carbs on my BMW F650 Funduro 1996 model. I ordered a repair kit that came with jets, o-rings and gaskets but since adding it all nothing but problems.
Eventually decided to strip it all back again and take a good look. Found out that these kits you can buy are rubbish. Different sized jets than originals and I even ordered another that arrived the same, different sizes and not consistent at all. My advice don't buy a cheap one!
In this video I show how to remove the tank and panels etc, plus removing and replacing the carbs. The bike now runs fine again :-)

Опубликовано:

9 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 21

@hdbkfl Год назад

Sir. You are the man! I have always been intimated by even touching a calburator, but you made it look easy. Thank you for making my quality of life better! Thank you, thank you..

@bezpopisu Год назад

Finally I found out, which float mount in which carb - I spoke about the jet in the plastic float funnel. Thank you!

@richardwhitehead4684 8 месяцев назад

Not having a garage, I also have to work in an old barn. Not ideal, but better than working outside. Fwiw, I just purchased a non running 1997 f650 and will pulling the carbs soon.

@PeterSmith-or3pq 5 месяцев назад

I've done this on my 98 f650 st . Little tricky ❤

@howrrmr.7172 Год назад

Happy 2023 with your 650!!

@user-hh9cu2px9g 2 месяца назад

It’s a lot cleaner than the turd infested barn I have to work on my bikes in. And the critters (woodchucks and squirrels) will chew on the rubber stuff. Ugh. But like another commenter said, it’s better than working outside…

@motoarchery Год назад

Wooowww. I got lost in that carburetor with ya, mate. Motorcycle bliss. My 99 f650 is still going strong, but she's lately been chugging a bit at lower rpms. I know its time to get down to that carb. Thanks for the excellent video.

@gerard3665 2 месяца назад

Thanks for the video. You are a good mechanic. You don't clean the carburettors with ultrasounds and you don't do the synchronization with a special tool ? It is not necessary !

@DJPresser 2 месяца назад

If you have an ultrasonic cleaner then yes do it! For balancing the carbs I just listen and ride until I’m happy.

@pawekaminski7607 Год назад

Thanks for the movie. Wondered what is correct position of this short cable with a spring that opposes the throtle cable at the left side of carburetor. I have turned it one way and the other and don't know how it should sit now.