It doesn’t matter what equipment you have folks, the bottom line is does the equipment work best for your needs? And no matter what, do your flippin’ maintenance, full maintenance and not half ass maintenance. Whatever effort you put into your equipment will always determine the results your equipment will have when being utilized. Not hating on anyone but lots of folks say that this brand is a POS or that brand is the best. A LOT of times, the POS equipment that the individual(s) are complaining about is the result from a lot of half ass maintenance. What’s best to you isn’t always best to others and what’s a POS to you isn’t always a POS to others. Everyone take care of your equipment and mow your hearts out. Y’all be careful now.
@@Duckologist101 Brilliant, I obviously didn't think of that. I let it run out of gas and changed it there, of course it was over a 100 yds away. Thanks!
One critical key point - Do not touch the breather vent plug on transaxles with internal expansion tanks. If you do, it will break internally, and you'll need to service the unit. This was straight from hydro-gear tech support. Another thing, hydrogear told me to fill the transaxle using the fill port located on the top of the unit until fluid comes out the top port which is located on the side of the unit. I know it's confusing but look at the drawing diagram and and you'll see. I think you filled it incorrectly in this video, but you might still be OK. Always consult your owner's manual or contact hydrogear if you have any questions.