I would love to see an install video on this new fence, I think that is an Axminster table saw you have, I have the same saw, but my fence has never been a problem, it is very repeatable, but I think with all of these chinese made things there is a lot of chance involved, as with you( my), tennon jig most things need a complete re build before they work properly. Stay safe! Chris B.
Hi Chris, new SD card installed and camera at the ready, the INCRA TS/LS is labelled as made in the USA so hopefully will be a breeze 😉. Yep the SIP is very similar to the Axminster version to, the fence was useable but I could never get it to run parallel and the scale a little bit coarse to read. So with a bit of luck this’ll fix all these issues 😂. Cheers Steve
@@Phenrica Made in USA! That sounds good, or maybe there is a town in china called Usa, I have bought a number of tools thinking they were made in USA, but when I took a close look there was a little sticker stuck up where it was easily seen, when I questioned the supplier/maker, he said we used to get them made in USA but the quality was so bad we now get them made in china! The only thing that put me off the Incra was that you had to go with the 1/32" increments. Stay safe! Chris B.
he might be first but he didn't bring an apple🍎 🍎 Ive seen a couple of videos about a new Chinese fence that looks at least as good as the Incra (can't remember where), but with the Incra on your saw you should be bang on accurate.