Briggs 206 Throttle Cable Installation 

We are glad you found this helpful!

Hi SparcoSenna! You can use a standard throttle cable, usually about .120" in size for the World Formula. Here's a link to an example: pointkarting.com/products/96-throttle-cable-extra-flexible-96-long-cable-with-a-192-diameter-ball-end-10-pack

Hey Titan Town - thanks for the compliments! We will work on optimizing them for RU-vid search per your suggestion!

@@PointKarting check out videos by Think Media or Nick Nimmin. Once I started following their RU-vid tips I've grown my channel 300%

Hey @Jerome Crowl - it sounds like you have an issue there! Without knowing the type of engine or kart, it can be difficult to say exactly, but we suspect it could be one of a couple issues: 1) your clutch may be engaging at a lower-than-desired idle speed. For example, let's say your engine idles at 2,000 RPM, if your clutch is engaging at 1800-2000 RPM then the rear wheels will spin. So, consider checking how your clutch is set up, if you are using a centrifugal (used on single-speed karts) clutch. 2) You may have tensioned your throttle cable slightly. Sometimes, if you set up your throttle cable to have too much tension when it should be at idle, you can get the problem you are having. While less likely, a kink or bend in the throttle cable sheathing can also cause this. Check your throttle pedal and make sure when it is 'relaxed' that it is truly releasing most of the tension from your throttle cable. If it is not, consider adjusting this. Most racing go karts have 'stops' or bolts that prevent the pedal's forward and backward movement to help you adjust this. These are our 2 best suggestions to consider initially if adjusting the idle on your Mikuni has not fixed the high-idle issue so far. Worth noting as well that the rear wheels slightly spinning at idle for many engines is not abnormal when the vehicle is on a stand or in the air - this is a consequence of the tight tolerances between the clutch drum and the internals on many racing karts. Hope this is helpful!!

Jon you can get it on our website - right here: pointkarting.com/products/96-throttle-cable-extra-flexible-96-long-cable-with-a-192-diameter-ball-end-10-pack

@David Gryczewski absolutely, you will need the needle. Without it, the engine will not run correctly.