BUDWEG | How to repair the piston and rubber parts on EPB Calipers - EN

Подписаться 153

Просмотров 11 тыс.

50% 1

In this video, we guide you through how to repair the piston and rubber parts on EPB Calipers.
We specialise in calipers. We remanufacture already used calipers and manufacture new ones. In both cases, we supply calipers which match or exceed the quality of the originals.
Visit our website and learn more: budweg.com/

Опубликовано:

27 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@Jonhenrysneip Год назад

Good done job

@mannyx1612 Год назад

What happens if the piston comes all the way out? And the boot has a cut in it.

@LACALISWAG Год назад

It could cause wear and allow water into the module. Should be replaced asap.

@AlinMadalin23 11 месяцев назад

Is it possible to replace the dust boot without taking the piston completely out ?@@LACALISWAG

@seriksson9721 8 месяцев назад

@@AlinMadalin23 Not with this caliper design. If you are wise, you change the pads in good time, then the piston and dust boot do not go out as far, better protection.

@AlinMadalin23 8 месяцев назад

@seriksson9721 yeah i changed them but when the piston went back in somehow it catched the boot and broke it..

@seriksson9721 8 месяцев назад

@@AlinMadalin23 I recommend a lot of silicone grease and using a spinning/ rotating motion when fitting the dust boot and piston. It's not quite easy, as you noticed.