Built a 1:35 dio house for Russian front diorama
Materials required, 10mm foam, plastic card, coffee stirrers, pepsi cans empty of course, pva glue, florist wire.
You will see how you can create loads of different buildings eith these materials.
More of my stuff in on instagram
0:00 Introduction
0:23 Still needs painting
0:44 Marked out basic building on Foam
0:49 Make sure blade is new, cut marked lines
1:47 Nails used to clamp pieces together
2:22 Pegs used as clamps
2:31 Coffee wooden stirrer for window sill
2:36 Using plastic card for wooden planks 6.5mm wide approx
3:17 Make and scribe bricks
3:21 Experimenting with a saw
3:33 Once all horizontal courses, make brick template
3:38 Then mark vertical courses
3:45 Will an old airbrush needle work?
5:47 Mark lines so cladding will be straight
5:58 PVA glue
6:01 Coffee stirrer again, sorry costa
6:39 Make wood grain in plastic
7:07 Check measurements
7:54 Notice the notch
7:58 Tamiya thin used to seal ends
8:31 Card board for roof
9:20 Clamp with drawing pin if needed
9:29 Door frame
9:34 Trying to make the ends of the boards look rotten
10:15 Corrugated roofing
13:04 Add PVA to roof
13:19 Using multiple sheets cover a larger area
14:02 Same for the larger roof
14:52 Pepsi can for roof trim
15:15 Super glue onto card
15:33 Fix plastic card strips down
16:34 Cut card board squares chamfer edges
17:13 Red strips added, colour from Airfix box
17:18 Door handles
17:25 Florist wire
17:48 Or use plastic card
18:09 Window just plastic card
18:14 Slide door in
18:34 Little bit of finishing trim
25 июн 2024
