Most pantographs that I have seen don't mirror the part like yours does. If you are plasma cutting using this and for some reason your material was different on the back side you would have to make sure you flipped it over before cutting. Most cuts won't matter... but some might.
Dave Simon yes as of right now it’s 1:1 I’ll be adding holes and finishing it tomorrow as i make the plasma table and demonstrate it . Check out the video tomorrow 😊
Thanks for the well done video! There appears to be no way to message you for the kit. YT used to have a way to do that, but it seems to be either gone or hidden. Next steps?
Bonifabcustom Rob Bonifacio I was trying to do your project everything was going find but cannot get proper pipe size to sit bearings in tight....I get some movement 🤷🏻♂️
