Building a custom console for the C10 

Thanks man I really appreciate it. I completely understand but sometimes it’s not a bad thing to step back for a little bit and assess the situation and then get back after it. Good luck buddy!!

This makes me miss my 82 c10

Thanks!!!

Thanks!!

Just regular 1-1/2 wood screws

It’s 3/4” MDF board. You can pick up from any hardware store

No problem. They are cipher bucket seats

Not too hard, you don’t have to be super elaborate. If you have a bench seat it can be as simple as a small box with two cup holders. There are some companies that make them but are really $$$. If you plan on doing it yourself the best thing to do is make lots of sketch’s and cardboard templates to make sure it’s perfect. I use 3/4 mdf board for the majority and 1”x6” wood boards for any structure as they are stronger.

@@kesselsgarage I'm planning on building an figure out how to put a decent system into it. But I'll have to figure that how eventually... Thinking 10s or 12s

I am assuming the floor heat will still be effective with the console in place? I have a 85 gmc c15 so this looks nice so far.

Thanks man, they are actually new Cipher bucket seats

1/2 radius bit

It’s a hand router with a 1/2” radius bit

Thanks man, it’s a slow process everyday after work but we are getting there. Good luck on your console.

Here’s the finished product! ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-OxCfeVex9DU.html

Thanks buddy!! I really appreciate it. I definitely like the looks of yours and the way your projects going! Glade to see you’re out testing it

3/4”

Appreciate it buddy!!!

Thanks! Which part is too wide? By the seats or the pedals or the whole thing. I think everything fit ok during the test fit but we will check before we finish wrapping it.

I ordered them from bass pro they are actually boat cup holders. www.basspro.com/shop/en/tigress-stainless-steel-cup-insert

Thanks!! I used a 1/2 radius bit.

@@kesselsgarage beauty thanks!