DXF files and build plans available here:
www.etsy.com/l...
I built this press brake in my personal shop. Some key features:
• Adjustable hydraulic jack locations - jacks slide side-to-side for optimal positioning dependent on work piece thickness and width
• Spring compensated and adjustable gauge rods for consistent and accurate repeat bends. Compression springs prevent damage to the gauge system in the event that the stop point is accidentally exceeded
• Upper and lower bending dies built from cold rolled 1018 for a typically higher material hardness than the workpiece
• Bottom die assembly that uses two 1.5 inch diameter cold rolled solid round rods
• Bending die will be cut into fingers to allow for box and pan bending operations
• Hydraulic jacks plumbed together for simultaneous operation but can also be operated individually for level adjustment
• I opted to use two 20 ton air over hydraulic jacks
• Adaptable, adjustable, modular, and easily repairable design utilizing minimal welding of components onto the main frame
For further viewing, here is a video of the press brake in action being used to build a wood fired pizza oven:
• Building and Testing a...
#pressbrake #homemade #homebuilt #shoptools #homemadetools #brakepress #hydraulicpress #cncplasma #industrialfabrication #cncplasmacutting #customfabrication #metalwork #welding #fabrication #steel #steelfabrication #fabricationshop #welding #hypertherm #millerwelders #mig #tig #fabshop #custombuilt #industrialwelding #diypress #diypressbrake #diybrakepress
28 сен 2024