Building V-Flats - Inside the Glamour Studio with Sue Bryce 

love it! thank you Sue for sharing, you're amazing

I love Sue Bryce so much

I love this! This is an amazing video! So great!!!!

No se como agradecer este video ,que felicidad . Muchas gracias!

Awesome tips! I've been getting into photography and have been looking for an inexpensive backdrops. This video helped a lot. Thank you.

Sue Bryce is awesome.

Add wheels to the 2x4 on the ends to easy move v flats

I hope this can help - On the foam boards, For the base make slots on the bottom . To be able to slide the brackets back and forth. This gives you room for all widths of foam board. Use large washers also they will help support the brackets - Then get a long screw with a wing nut to tighten it. Also so you can then take the foam board out to store them for later use and be able to use different ones with different colors. All in all this is a good idea what was done on the video. Also if you can use butcher paper and clip it on the foam board - paint over the butcher paper so you can just 1 foam board. Lots of ideas.. Sue is excellent she always goes the extra mile on many concepts..

Amazing... This information is free.

Thanks for sharing!

Maplins in the UK used to sell cycle stands with 4 little wheels on, which make fantastic Poly board stands !

You can also use High Impact Polystyrene sheets as diffusers and easily shape them using heat :D make sure they are super thin

I like the idea however I would put hinges on the side of the 2x4 connect two panels. I would not bolt the panels to the shelf angle brackets. This way I can V or L shape the flat white/black side. Maybe instead of the shelf brackets I would use 2x4s about a 29 inches ___|_|___ try to visualize this to be the one 14 inch 2x4 laying flat and two about 29 inches high stand upward on the 2x4 with enough space to slide the foam boards. Make two floor holders and put a hinge on the end connecting two when you v shape the floor 2x4 holders you can then slide the boards so the they touch or one can slide this L or over the other edge like this |_ or just anything between 10° to 90° or two panels wide open side by side creating a larger backdrop.

Nut and Bolt, not screw, screw goes into the 2x4 wood stand.

Can I have peel plastic of polystyrene for colouring polystyrene sheet?

How do you go about finding a assistant, and what should you pay?

So what's the youtube of her friend? Not even a link to her?

They are not "screws" darling they are nuts, bolts, and clearance washers.... a screw by definition has a sharp point on one end no matter the flavor...

They're bolts, not screws. Nuts go on bolts, just for future reference.

Canada the sheets are $50 bucks a piece. Cost me $160.00 for two.

Thanks for sharing! This is awesome! However, neither Lowe's, Home Depot or Menards has anything with a clear white side it's all silver. Where is everyone else finding these?

We called them Go-Boy's.... Excellent hack.

I peeled off the clear plastic and with a roller painted one side black, but I can't get the paint to completely cover all the crevasses even after three coats and dabbing spots with a brush. It might be better to keep the clear plastic on and paint over it. Also, I'm leaving off the stand because it will make the v-flat too tall for my low ceiling (and I already cut off one foot of the board). I'm going to tape a hinge support to the back like in this video: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-eUQGRMBIPRk.html My studio is small so I won't use it as a backdrop, but it will work as a light blocker.