Click here www.roofbox.co... for more information.
What's the big deal about the Buzz Quattro?
The Quattro is supplied almost fully assembled.
After attaching both uprights, loosen the tow ball locking knob and lift the carrier onto the tow ball.
With one hand holding the carrier level, use the other hand to tighten the locking knob, hand tight.
Once locked with the keys provided, the locking knob will spin freely in the locked position.
Depending on the tow ball size and shape, the conical clamp may not sit fully inside the housing, but, as long as there is an equal distance all the way round, the carrier is securely fitted.
Using the spanner provided tighten the collar nut and make sure there is no side to side movement.
Attach both brackets to the light board using the tools provided.
Slide the light board onto the rear of the carrier and attach using two of the 45mm bolts provided.
You only need to attach the light board the very first time you use the carrier.
Using the cable ties provided, secure the wiring to the frame, making sure to position to the left side of the tilting bracket.
Open all the wheel straps on both sides before fitting the bikes.
Loosen both uprights and lay them flat
Place the largest bike closest to the car with the gears and derailleur facing the car.
Holding the bike with one hand, secure the upright into position.
Loosen one of the bike arms and position the jaws around the bike frame. Once in position, tighten hand tight.
Tighten both wheel straps
Load the next bike making sure it’s in the opposite position to the previous bike.
Place the bike arm jaws around the most accessible part of the bike frame and tighten, hand tight, locking when you’ve finished.
Load the third bike opposite to the second. Adjusting the peddle’s if required.
Holding the bike with one hand, use the other to lift the upright and secure into position.
Taking the nearest bike arm, place the jaws around the bike frame and tighten.
You can attach the bike arms to seat posts but only on one of the middle 2 bikes.
If the fourth bike has stabilisers, these must be removed prior to fitting.
Again, when fitting the 4th bike make sure its opposite to the 3rd bike.
- The Quattro can accommodate a wide range of wheel and frame sizes -
Position the remaining bike arm onto the bike frame and tighten hand tight, locking when you’ve finished.
To operate the tilt, release the retaining wheel. You can use the bikes handlebars or frames to pull everything towards you.
Make sure you keep hold until the carrier has reached its full tilt.
This should now leave enough room to open and access the boot on most cars.
Now simply push the carrier and bikes back up to horizontal and reposition and tighten the retaining wheel, hand tight.
Attach the electrics.
The Quattro is fitted with UK standard 3 function lights using a 7 pin plug.
Using the tool provided, fit your number plate.
Any UK standard car number plate will fit.
This video is not a replacement for the official BuzzRack instructions included with the Buzz Quattro.
Click here www.roofbox.co... to see our full range of bike carriers.
26 сен 2024
