Here is iq8 control pannel. And 2 different loop have 2 fault at diffrent location. First i did clean the device and after make reset. Again fault came. After i did change that smoke with base and make programme of replace smoke. But after some time again fault came. So now what i do? Because i follow all step of solve the fault but fault again came. I also check his dc supply in device. And there supply is 18-20 v dc. Can you suggest me any idea for solve this problem? Please
Dear Mr. Afzal, your comment was provided to the video, demonstrating how to connect Esser IQ8 panel to the C4 management and monitoring SW. Where/How do you observe the problem? Is it visible In C4 software, or you are setting up the IQ8 panel standalone, without C4 software? Let me know in order to find the best answer for you.
Dear Mr. Afzal, what type of failure do you receiving? Is it fire alarm or just tamper on the detector? Also if you used the smoke to the detector it still may be stacked in the detector, please try to take the case of the detector down and "clean up" the detector.
@@markvarjasi1809 i did clean and after replace that smoke from new smoke with base but again came fault. In pannel he showing me like this 1. Fault - zone:1500 dev:16 location det when i press in pannel param. txt. then he SHOWING me tr:012 so what is the solution of this fault