Cabon Steel Poor Cut | Fiber Laser Cutting | Problem and Solution 

Thank you so much Clara for sharing such helpful information my laser cut is now cutting smooth. You gain a follower.

Спасибо, Клара! Ваши советы просты и гениальны! Ваше видео - жемчужина для тех, кто, как и я, в начале пути лазерной резки.

Thanks. Very good presentation of information. Everything is precise, short and clear.

Great video and helpful information. You are doing such a great job with the information you share here.

I am a cnc fiber laser operator and your videos very helpful ! Thanks for the knowledge 👌🙏👍

Çok iyi izah edilmiş. Teşekkür ederim.

thanks Clara Chai , much needed videos😊

I just found your channel. Thank you very much for sharing your knowledge

thanks for help so much

Thanks you

Hello Clara. Tks a for for share your knowledge.

Hi Clara! First of all, you are the best! Finally I found someone how teach me how to get better cuts as a fiber laser operator! I got a question for you, is the mirror edge the only "good quality" cut? Maybe you can make a video about what to consider a good quality cut. Thank you for helping us!

Thank you so much for tips and Cut Again 😊

thank you for helpng us

Thank you

thank you

Thanks you very very much❤

Thnk you so much

Dear , very helpful video Thanks,,,,, Pakistan

Great videos Clara, thank you. Do you have one like this for cutting aluminum? With tips and tricks?

Great video. Can you do a video on galvanised steel cuts and main problems? Like too much dross on the bottom side.

Thanks a lot for the video. Amazing info. Can you upload about parameters of air?

Hi, thank you for the information. Can you show how to set cutting for 6000kw from fibre laser cutting 16mm mild steel. Thank you

Make one about Aluminum too, thanks 😊

Can you direct me to one of your videos in which the layer parameter setting "beam width" is explained? Your videos are fantastic. I will most likely join soon.

Hi Clara I have question about flow rate of oxygen. If we have raycus 1500w laser source and cutting 5 mm of mild steel by oxygen how much the flow rate of oxygen gas

I have a 3000 watts laser and I’m trying to cut stainless steel with oxygen; any suggestions?

hi

Remove not burr cricle dia

SS 20mm N2 cutting 6KW Raycus source not proper cutting

thank you very much for these instructions .have any whatsapp no?