I've seen this done by many other makers here and thought I would give it a try. I have a knife that needs a little straightening and I already have the handle glued on.
Come take a short journey with me as I try, and fail, to get this done today. I learn a lot with each attempt to make something, especially when I'm not successful.
I purchased the 10 oz. ball peen hammer and 3/8" carbide ball bearing from Amazon based on the recommendations of another maker.
In hindsight, I think I should have looked into a brass hammer as it would have been a whole lot easier to work with. But, since I started, I'm going to finish this in a future episode. I need to get good set of Cobalt drill bits (the kind of metal, not the brand).
26 сен 2024