Carburetors cleaning and restoration - Honda CB Seven Fifty project - Eps19 

The looks

Could you please tell the capacity of your ultrasonic machine and what you use for cleaning ! Thanks . ( I've been doing mines for 2 days by hand :) . Your video/job was the real guidance .

Hoi, je kan alles vinden in deze winkel www.hbm-machines.com/nl/p/hbm-32-liter-professionele-ultrasoon-reiniger?_gl=1*1imjmtu*_up*MQ..&gclid=CjwKCAiA0JKfBhBIEiwAPhZXD_ci9GrGOcDrlIyFKz04JEhSjvRHrnpd-MG-M-_FrPtdgaz84X3gChoCIe8QAvD_BwE

With this screw you can drain the gasoline from the carburetor float chamber, and you are right in the service manual this screw is not described.

Hi. It's Honda CB Seven Fifty RC42 european model, in Japan it's known as CB 750 RC42. I bought the entire repair kit for these carburettors, although I only used idle nozzles and their seals, and the o-rings of carburetor connectors, the rest were still in good condition. You can buy all the parts by www.cmsnl.com/ but they bit expensive, or you can order parts direct from Japan by buyee.jp it is kind of shopping service in Japan, they collect all the parts you order and send it to your country.

@@MotoAndy thanks a lot!

it depends on many factors, type of carburetor, type of jets, type of exhaust, etc etc

@@MotoAndy ok, Thank you very much, you do a magnificent educational job

Thanks, so far I have not noticed any problems with the E10

@@MotoAndy That's good news. I'd seen some info suggesting it goes for anything copper based and some elastomers used in hoses, and tends to phase out any water in fuel in the tank (possible corrosion risk). Versys will be fine but I wondered if Honda now supply E10 resistant replacement parts as std. Anyway....sounds good so far 👍

@@PAUL-yv2kk we'll see what the future brings