case 931 injection pump stuck fuel rack fix and service information pes6a pump

Подписаться 214

Просмотров 7 тыс.

50% 1

hello, sorry bout the long time in between videos been busy with work and life. heres a short video of how i unstuck the fuel rack on my case 931 injection pump. couldnt find any decent videos explaining how to do things, so i made my own. if your havent removed the injection pump yet , you have to line up the timing marks on the pump gear housing before removing the pump. very important. i hope it helps someone, feel free to comment and ask questions ill try and help as much as i can.

Наука

Опубликовано:

1 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 10

@jeffvanderveen2890 9 месяцев назад

Excellent. I'm going to try snd start an old 930 Case , been sitting awhile .

@johndowe7003 9 месяцев назад

Good luck bro. This one had sat for about 15 years, runs great now. 3pt lift cylinder is stuck though. Future video on that maybe..

@tanksoldier9770 2 года назад

the engine is on my N H Swather i think its the same pump like yours thanks TANK

@justinontman Год назад

Hey, can not find anything about these tractors hardly. I pulled my pump due to a stuck rack. I was not thinking about timing when i done it. Do you happen to know how i would go back together with it? Thanks in advance

@johndowe7003 Год назад

If you removed the pump without the timing marks aligned, turn the motor over with a breaker bar until you see the timing mark on the gear on the pump drive side of the engine. Then turn the pump over by hand until the gear matches. Careful because you can get it off by a tooth very easily. The pump does move around but from what I saw it doesn't work like a timing Advance on a old dizzy. You have to get the gears meshed just right.

@deweydodo6691 Год назад

I have to pull the governor housing off mine. Just puking out motor oil on the throttle shaft. Someone should do a in the shop full disassembly video of this .

@johndowe7003 Год назад

Good luck with that, I had a hard time finding information on this. Every shop I called wanted anywhere from 2000$ to 4000$ to do what I just did in the video. You can probably just rtv it and call it good. I honestly don't even know where to begin to find parts far these. I had found a seal kit but I don't think it was the correct one so I didn't get it

@tanksoldier9770 2 года назад

hay there i have a ford diesel that seems to have the same problem from sitting to long thanks for the video TANK

@johndowe7003 2 года назад

is it a 7.3 powerstroke or the older IDI engine? what you could try is diesel kleen i use it all the time and it works pretty good. if the truck runs put a whole 32 oz bottle in the tank and it should fix er right up.