Yeah that’s the most annoying part about the speaker. I never know what level the battery is at. I got this speaker as a free gift but if I were to pay, I’d buy a different speaker.
Is there a way to see the battery percentage on my cell phone? I have a very cheap little Bitty Boomer Bluetooth speaker that shows the percentage of the battery. However my JBL clip 4 doesn't have this option is there a way to enable this or it's just not possible.
It’s sucks. Makes no sense. Could’ve added this for a few bucks. I would’ve paid. I don’t know how they over looked this. I need to know 10% or 90%. Geez.
Hi, as long as the fast charger supports an output of 5Volts (5V) it is safe to use without damaging the speaker. The supported voltages can be found in the small fine-print on the charger.
@@chippiechips2248 mine to. And i fully charged it. I dont get why they say it can play for 10 hrs or so when i played ot for like 5hrs too at full volume. I expected it to die at 6 or 7 hrs
I think that's what I'm experiencing RN I changed several charging cords but still the red light to indicate charging doesn't come up , could it be that the charging port is bad?
Do I need to power on the clip before charging? Or do I just leave off and plug in the cable? When I plug in cable without turning on, the light does not come on.
I wanted to know how to figure out how much percentage it has left. For example if it had 40% left or 10% left, cause what if I wanted to take it out but it’s close to dying.
Why on your video the white signal light on your JBL speaker will blink and then when it's fully charged it will stop blinking and just be white all white why does my speaker when it's fully charged the white light it just blinks blinks blinks it doesn't stop blinking what does that mean
I am trying to charge my recently bought JBL Clip 4 for the first time using my iPhone charger but it won’t fully charge. It has been eight hours now but the led indicator is still in red.
i have the same issue as well! i have left my jbl in the port for the whole day today and saw that the led light had turned off. i replugged it back and it and it seems to still be charging since the LED is still a continuous red.. :(
Hi, I charged my JBL for 3 hrs and then I remove it from the socket because the LED light turns white. But when I tried to connect it to the socket..it turns red again. What does it mean?
Hi, it is normal for the red light to turn on first when plugging it in. In case the battery is fully charged already, the red light should turn off after a few seconds.
@@MegaSafetyFirst When I first plug it in , it shows red light but later sometime it doesn't display any light does that mean it is fully charged ? But manual says that it takes 3hrs to get fully charged
Correct, when the light turn off it is fully charged. It will only take 3 hours to charge when the battery was completely empty. Otherwise it takes less time.
Wow, no way to check battery status via your phone? Not cool for a blind person who can't see LED indicators, come on now, I know it's a sighted world, but sheesh. Guess I'll just have to charge it every couple of nights.
Totally Wrong Information, you cut the power of electricity, then it's blink white, adn for your information, when you on the jbl clip 4 then no matter battery percentage but the light will blinking😂