Is the racking arm set in the up/down position? Is there enough suction to actually pull liquid through or is it all just going out the bottom dump valve?
Hi I’m using exactly as you have shown. Works well BUT I am getting entrapment between tank and tri lamp fittings. Run hot caustic 30 minutes then hot rinse. How do you overcome this.
I would like to find a barbed “T” exactly like shown in this video, but all I can find are little three-way splices... not heavy-duty at all and ID doesn’t seem big enough. What exactly is the part used in the video for the T? Thanks and cheers!
I found this PDF with instructions and a parts list from SSBT. This document does not use the racking port and tee though. ssbrewtech.zendesk.com/hc/en-us/article_attachments/115016965366/CIP_MICROsprayBALL.pdf
I put around 3-4 gallons. Enough for transfer port to pick up liquid while the pump is running. For a 7gal unit it would be less id say probably 2 gallons
Does the Micro Spray ball really get the job done? I tried the regular version on my Unitank with a 1/5 hp or chugger pump and it was pretty much worthless. Looking at the micro ball.
The key is pbw between 130-180 and run it for at least 30 minutes. Make sure the CIP ball doesn’t get clogged. You will hear when it does. Also don’t use too much water. 1-3 gallons is all you need.
Louis Castellanos PBW, fresh water rinse, Acid Cleaner #5, fresh water rinse. Then Saniclean before use. Starsan creates too much foam for use with CIP sprayers in conical.