Coffee bean serving tray - Servírovací tác s kávovými zrny 

Пигмент находится в нижней части. Это видно после поворота лотка :) Фиолетовый металлик. Спасибо

😲 😊 thank you

Thank you very much and sorry for replying only now. I use Finixa One step polishing paste.

I let the first layer harden so that the grains don't float to the surface when I pour the second layer. If I had to do the serving tray again today, I wouldn't mess with it so much. I would use sandpaper with a maximum grit of 1000 and would not polish. I would coat the tray with a thin layer of epoxy and spread it out. This way I achieve glossiness and, above all, evenness better than polishing. I use Finixa One step polishing paste.

The mold is made of 10 mm plexiglass and the parts are glued with double-sided tape. Unfortunately, I made the mistake of wrapping the inside with yellow paper tape. The tape peeled off after pouring the epoxy and I had a problem with it. So you can use insulating tape, but not paper tape. It is important to seal everything properly.

Hi, thank you :) This separator is no longer produced and was only available for the Czech Republic. VEROPAL RA100

It’s the first pour where the beans were put in.

I will estimate the ratio. I always prefer to mix less resin. As it has a long setting time, it is not a problem to mix :)

Because it's low-quality and nasty-tasting coffee.

@@nitronautcz hell sir where are you live .... i want to work with you, if you don't mind....