Coleman model kt196 keep Stalling 

I had the same problem. I cleaned the carburetor, added new fuel with some sea foam fuel additive. It ran rough for a minute and then ran fine afterwards. No issues since.

What a sweet kid hope it gets fixed

Did u ever get it fixed ?

When you start it don’t push the choke all the way up push it not even half way. Hope it helps

Sometimes you just have to give it throttle to get them warmed up. They don't like to run when there cold

I'm having the same issue, I even put a different carburetor on it that I know for sure was running fine and still stalling and will not accelerate

Here’s the answer. I actually have one of these myself. But the reason it stalls when you move the choke is because you must move it slowly or I WILL stall the engine. See if this helps.

Make sure the gasoline turn valve arrow is pointing to on. After your go-kart motor starts don't turn the choke off and let motor run a couple minutes to warm it up then turn choke off. Hope this helps you buddy 👍

I had the same problem too I don’t know for sure if this will work but you should try adding fuel and replacing the oil

When you get them, they start up as first pool but in a year so they take like three or so so you should give it some gas if it’s stalling on you

My friend had the same problem we kept putting the gas switch back and forth and it worked

When you when you turn the choke on, you have to turn the choke on yeah like you did but like one second later, you have to put it like back on the run so you can drive it and then it won’t stall

Your float in the carburetor, it might have some stuff in it

This fixed mine turn the choke of slowly or leave it on partly then turn it off

My does that too, you just have to let it run on choke for like 5 mins

Hey! If you are still having the same problem when you pull the starter and after it turns on leave then choke in the position towards you. Then let it run until you hear a stuttering sound almost. Where the engine sounds different than normal then put the choke back.

You need to clean the jet. Mine was having the same problem and the jet needed cleaned. On the carburetor there is a black screw. On the screw head there is a cap. Remove the cap and unscrew. Then pull the black jet up out of the carburetor. Take some compressed air and blow out the jet and the hole that the jet is in. This should let the gas’s flow through the jet and into your engine.

Hit the gass😂

Hello there did he ever get his go-kart fixed?

Try leaving the choke on a little longer and give it some gas and then after warms up a little bit turn the choke off

Try putting a little bit of gas in a carburetor not that much and then crank it over and it should stay on. That’s what I did for my predator go kart.

You do not need to give it throttle the run, but it would be better if you did try it

Same problem

Clean carb maybe

Turn carburetor back half a turn. Float is sticking

Give it gas

Turn choke OFF after starting it

egomaniac I just had the same problem

You need a new centrifugal clutch

Top speed???

Adjust the cable

Otherwise, your float in the carburetor is bad and you have to get a new one or just buy a new carburetor

rev it at a cirtin rpm

turn off the choke after it starts

It might be the clutch you need a new clutch

You need to let it idle for longer so you can ride it without it stalling or you need a new battery

Clean the carburetor

When you start it you need to turn on the choke and when it starts turn of the choke

You have to turn the choke off I’m a micanic even tho I’m 12 my 20 year old friend hired me

You need to get a new spark plug

de cus themoresbocen

i could not understand wut the kid sed

pisdnst

Same

You do not need to give it throttle the run, but it would be better if you did try it

When you get them, they start up as first pool but in a year so they take like three or so so you should give it some gas if it’s stalling on you