Converting a TBI truck to Carburetor And a bunch of other stuff 

Glad I could help

Thanks

Thank you Junior. Take care!

Yes sir. Thank you for watching

Thanks for watching

That’s buddy

thanks for theinfo about to do a cam carb swap on my 88 siverado

I problem. Glad I could help

Thank you

Thank you sir

I got a 1998 lifted 4 x 4 on 37s extended cab short bed 5.7 L Vortec I'm currently using some of the computer it is currently controlling my fuel pump my distributor crank sensor and cam sensor coil pack an O2 sensors and my 4L 80e transmission while running high-rise manifold Holley 650 fuel pressure regulator with return line and my truck runs like a beast also new timing chain mild stage 2 cam I'm still running my O2 sensors no catalytic converters stock exhaust manifolds width 3 inch to a Flowmaster dumped at the rear axle

Thank you

Thank you

Ok.

Yes, the edelbrock are really good carbs. I run them alot

Thank you Bud.

Thank you

That’s cool

It was running really hot, and rough. Had the wrong style spark plugs in it. Huge vacuum leaks, etc

You could keep the factory one in the tank but you have to run a fuel pressure regulator

If one comes thru someday I will do it.

ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-J0kmFOOiX-U.html

You can angle drill the center holes but it’s really hard to get them to seal.

👍

30x40 inside. And another almost 20ft under roof outside

@@HarmonGarage thanks brother

No problem

That’s an electronically controlled transmission. If you switch to carb you have to get a stand alone transmission controller for the trans

You can always swap the tranny for a 700 r4

No you do not you don't have to buy that stand-alone b******* my truck shifts just fine only thing I replace was my intake manifold put a 650 Holley carb fuel pressure regulator and the rest of the is running off the computer so I don't have a whole lot of timing to play with it's already preset

Tps sensor

Not to go from tbi to carburetor. But you can buy a carburetor intake to do the swap

@@HarmonGarage ok thanks I seen the intake didn't want 4 bbl would like it simple and good on gas those electronics give me a lot of problems broke down 4 times

This was a non tbi engine. Somebody put an older sbc in the truck with the tbi intake and the bolts being different was most of the problem

Not bad

if shes a good girl GRACIE PERHAPS?

Not a bad thought

This truck had a th350. It had been previously swapped

So the mechanical pump doesn’t have to pull fuel thru it

You should be able to use the same tv cable.

@@HarmonGarage Should I run a torque converter lock up kit? thank you so much for your help

Your torque converter lock up should still work. If not watch my video on putting a 700r4 in the white squarebody and I show how to hook up the lockup

@@HarmonGarage Thank you so much!

Glad I could help

This truck did not have a 4l60. I didn’t have to do anything for the trans

@@HarmonGarage I appreciate your response about the TPS hook up and after researching about it this afternoon I think I have figured out what I have to do

Good deal. Best of luck with your project

@@HarmonGarage I appreciate it man it's been a long while since I have had a project I'm really enjoying getting greasy again and having fun good luck with your projects from the video it looks like you have a couple

Thank you

Could be

Yes sir

@@HarmonGarage best thing I saw was a exhaust manifold welded onto the head to stop a leak haha

I’ve seen that before also

🤟