I am trying to measure all the streets in a specific development. Sometimes I get into a dead end and will like to change the end point I click on another point and the dot changes to a blue square. However when I click another point it jumps from the next to last point. How can I prevent that?
Thank you for the video. I had tried the procedure explained in the video to measure the slope angle for my study. The slope angle that I had measured was around 22 degrees. But actually it was observed that slope angle is 45+degrees. What is the reason for the difference in the slope angles?
does anyone know if there's a way to make the vertical exaggeration 0 in the profile view? adarshs question gets at this. the vertical and horizontal need to measure 1 to 1 to get an actual profile view instead of an exaggerated one. it doesn't seem to be possible to do this though.