DeWalt DWE7492 - adding extension table and installing a nice big drawer... 

Nice build! The outfeed extension looks superb. Cheers 👍😎🇦🇺

Endelig en video med mål👍

Endelig en video med nogle mål 👍

Gold job!

Beware. I had the same type of digital level gauge (I think...), but I recently discovered it was really not very accurate Almost 0.7 degrees off when measuring normally, just using the bottom face, the magnetic one. Always good to double-check. One particular weird thing about it was that it also showed over 3 degrees different when rotating it 180 degrees while it was stuck magnetically to the blade. It also was 1 degree off when placed upside down, and showed nearly 1 degrees different if I measured on the opposite side of the blade (still referencing the bottom face).

Round over your edges on your out feed extension

Good job !!

Really nice addition 👍 But , please buddy, be more careful with the table saw. I noticed a few critical mistakes against your safety. 🤜🤛

Nice job indeed, but where the upper parts of the extension supports hang, I have not seen your solution well.

Parabéns! Tem como disponibilizar o projeto? Obrigado.

Понравилось!

👍

Buddy crosscutting without miter, buddy you are lucky no kick back happened, beside that I love the stand and extension I'll follow same once I get mine next month. I think you may need to extend t slot to extension if you need to use sled

nice video, what drawing tool are you using to create the drawing sketches shown in the video ?

muito fixe

ca manque de plan et de détail de montage !

Really smat design！May I have the outfeed extension sharp3D file?

👍

Thank bro

I like your table but I'm wondering, isn't it unstable on wheels ? Can you cut full size plywood on that thing ?