Diresta inspired steel sawhorse build - By AMbros custom 

Thanks brian

+Ali Ifraid thanks Ali bro...

Thanks brother:)

It's my house dear. Which was recently constructed at that time.

+Deepak Singh thanks buddy....

serralheria

A mi me gustaron los shorts y una mano sin guante para soldar. Hay ojotas y crock de seguridad. Me pregunto si usaran mascara y proteccion facial al amolar. El trabajo es bueno pero esta gente no se cuida y pone en riesgo a quienes lo siguen!

thanks for the kind words ..........................and yes those latches are necessary because when you are placing something over the sawhorses it's obvious that they are spreading outward but when you are dragging something like an 8X4 sheet of plyboard, you observed that the legs tend to close.To stop that movement of legs those latches are necessary.

AMbros Custom Thanks for the info....

Dear it's because I don't want those lesgs to cover wider area at the bottom. The angle closer to 0° and 90° any of them can be considered for marking. The motive is to offset the legs away from the centre. Suppose you have English letter A, this is how side of the sawhorse look like. You need to make this letter, the more angle you choose for the sides which are meeting at the top, more will be the area covered by the legs and the hight will decrease if you already cut the material and if the angle is less than the hight will increase and the bottom area covered by the legs also decreases. So it's completely depend upon your design. The thing to note here is that if you draw a straight line from tip to the bottom and then this will divide that angle into two parts. Now measure that individual angle and cut that piece. If you didn't get that then you can send me pm. I explain you with pictures. Don't trap between 70°, just pay attention to what I described here. Good luck.

@@ambroscustom thanks. I want to try to repeat your job, more immediate than di resta one, imho. It was just to know.

Good luck:)

That's a 15deg cut or also be marked as 75deg, both will be correct

Hahaha.......that's a pretty old build buddy. But now a day I take care during my builds. Thanks.