Discover How to Block Out a Datsun 240Z with G2 Featherfill!

Подписаться 17 тыс.

Просмотров 1,4 тыс.

50% 1

Datsun 240Z Project Blocking Out Featherfill G2
I show you how to block out the Featherfill G2 to get an awesome foundation and super straight panels.
Product I Use
House Of Kolor K20 Post Sanding Cleaner amzn.to/3ESE7wQ
Evercoat Metal Glaze amzn.to/41XQG47
Evercoat Plastik Honey amzn.to/3ISVH5f
3M 220 Grit Wet Or Dry Sand Paper amzn.to/3IN0Ag1
3M Rubber Sanding Block amzn.to/3ZDvZIr
Sanding Board amzn.to/3JfaZSU
Zep Spray Bottle amzn.to/3kIa5Fo
Thank you for tuning in.
Please Like & Subscribe
Comments and encouraged and appreciated
Thanks again,
Troy Kane
vtwinstov8s.com
/ vtwinstov8s.com
/
/ troymkaneinc
New Videos uploaded on Weekly

Опубликовано:

28 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 18

@landonmarx4753 Год назад

Looking good. Very straight and smooth!!

@troykane Год назад

Thank You!

@michaelfolchetti4624 Год назад

Why 220? I would start with 150!

@troykane Год назад

Good question! Evercoat recomends 220. The finer the paper the less chance of shrinkage later on. Plus I like to sand wet so I have less dust and 220 is wet or dry is readily available.

@Handlehandlebars 8 месяцев назад

No.... it dosnt ever recommend blocking with 220..it recommends finishing off substrate with 220 before shooting the g2....

@yanowski5645 4 месяца назад

life is too short to be rubbing shit down like that .....

@troykane 4 месяца назад

Sorry that's what it takes. 40 plus years of this and many Best Of Show Winners.

@ColoPonchoMan Год назад

Thank you for this video, and for not dropping f-bombs, etc. I am an amateur and have a few questions: I am surprised that you are shooting the Featherfill right over bare metal, and am wondering if you did the same (direct to bare metal) on your Impala many years ago? Have you also used Featherfill over bare metal on other projects since then? If they are holding up, it would speak to the endurance of using Featherfill direct-to-metal. I am blocking out my guide coat (over 2K epoxy primer) this week, and was concerned about spraying the Featherfill over bare metal areas where I block sanded through the epoxy, but it sounds like this isn't a problem, correct? The can says it's ok for bare metal areas one inch in diameter or less, and I have sanded some areas larger than that where metal is starting to show through. Thank you again.

@troykane Год назад

I hope I did not mislead you. I applied Kd3000 Expoxy onto my bare metal surface 1st. The applied featherfill g2. Cut thru to bare steel can be handled with an application of KD3000 sealer just prior to recoating. Hope that clarifies things

@ColoPonchoMan Год назад

@@troykane My fault-looking again, I see that I missed where the text in the video stated that you used the HOK direct to metal epoxy before the Featherfill. Thanks for clarifying!