No video :(

DIY Backlight or Decor or Christmas LED | WS2812 | Wemos D1 | WLED

Подписаться 49

Просмотров 15 тыс.

50% 1

A simple way to make a Christmas LED or lighting for a room or table
You will need :
WS2812 LED - ali.pub/5e3hrc
WS2812 RGBW - ali.pub/5k84fq
Wemos D1 - ali.pub/5e3hu2
Extr:
3PIN LED Wire - ali.pub/5e3hxr
or
3PIN LED Connector - ali.pub/5e3i1g
WLED WiFi Password : wled1234
Software
WLED GitHub - github.com/Air...
ESPHome-Flasher - github.com/esp...

Опубликовано:

27 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 14

@anupsonawane1420 Год назад

Can we use esp8266 nodemcu instead of wemos d1 mini ?

@JAMESDOOM22 Год назад

Hello, I'm using Wemos D1 mini and WS2811 then the LED is unresponsive. Any ideas?

@jmclsn 3 года назад

How much LEDs have you used? And worked it well without an external power supply? I heard it wouldn't but idk actually...

@Thanks-Again 2 года назад

I was just googling this specifically. Looking at the board it appears that the 5v stuff is a bit isolated from the 3v stuff, so I’m going to push my luck and see what I can get away with. At $3 a pop it’s kind of “whatever” if I fry one

@mark47killer 2 года назад

@@Thanks-Again can you please tell us the outcome of your result when you took 5v output directly from board. And how many led you used

@easydiylab1590 2 года назад

Maximum I connected 120 LED directly from the board to the wemos d1 and they have been working for over a year.

@aaronalcantara9791 Год назад

@@mark47killer you can use external 5v psu splitting power for the wemos and the led, if you want to achieve the whitest white, use 5v 3amps :)

@yanir9299 2 года назад

what are you put for solder?

@easydiylab1590 2 года назад

This solder paste alli.pub/699kb9

@akblast-tamil-yt7727 3 года назад

I want to use in my motorcycle helmet.can I use powerbank to power.pls help me

@easydiylab1590 3 года назад

Yes you can use power bank

@tutwirata8956 2 года назад

Still dont't get it. Where do i can assign /create my own SSID username and password on this WLED ?

@easydiylab1590 2 года назад

After flashing the WLED in the controller, you need to find an open WiFi point, connect to it and specify the mode, or it will be a separate access point, or will connect to your wifi network and then access will be by IP address that will be issued by your router.

@tutwirata8956 2 года назад

@@easydiylab1590 Thank you for your quick response. I will look into this.