Sadly I slung the chain on my gsxr at the end of last summer and is slapped a small hole in the engine case and since replacement engine cases are so expensive I believe high temp jb weld epoxy will be the way I fix it
Hi bro ...in the area of engine oil drain bolt .. there is a crack due to over tighten ... Now it started leaking ... No I am using mseal to fix it .. but not satisfies ... Want a permanent solution ... Can you the share the link of this ... Do yu think this will help my case ... Pls share ur idea
I am having the same problem talked to a few people said drain the oil put it on her it on watch the oil leak and see if it leaks be aware and see if it leaks to top off I am doing it tomorrow
@@jeffbezos4746 yep. And I’ll weld it every time before I JB weld anything ever again. And if you happen to use JB weld before having it properly fixed good luck. Because you have only made it worse by using it.
@@nicholaskominski3746Until you know how to etch the surface of the damaged area, then most likely you would feel that way. Take a Dremel and grind out the damaged area and clean it with PVC primer and the JB beats having to split the cases to weld it.
@@about2mounti have a cracked engine just infront of the front sprocket. I used jb weld and it still leaks. How do i get it off the best way to weld it properly.