DIY FIX Wet Passenger Floorboard Porsche Cayenne 

Fantastic presentation and has the same experience. I also, noticed that the air intake vent and area was full of leaves. Had to peel back the passenger side fender liner and clean out the rubber drain at the fender.

Porsche needs to hire Gutter design engineers and kick out current garbage design engineers since they can’t design simple drain system and likes to collect garbage in their drains.

The hardest part of the job is removing that clamp they used- you would think that it was there to hold 40 lbs of pressure. I used a cable tie when I put it back together to make it easier

How did you take the tube off? It’s so hard stuck in there 😭😭

I have porsche cayenne 2009 , when engine heats up , its won't start Any I ideas 💡. I changed battery, Raley, the dynamo starter . Still facing same problem

2015 Cayenne S e Hybrid: Despite limited visual access, you can open the hood, and feel along the firewall to flip the rubber vent door to open the AC drain. This took 2 minutes to clear, and can be your 'go to' maintenance approach. No need to flush under the dash end. If you have some concern that cutting the flap off could give mice access to the cabin, here's a fix I tried: take 10 OD mm silicone tubing and cut a section to run inside the black rubber AC tubing, and extend 2" beyond the vent flap. I also fit 2" of tubing length into the hard plastic funnel end of the AC housing under the dash, as I had already removed the tension clamp from the inside.

Hi! How do you get the drain hose clamp off?

Thank you!! ❤

Порш они все ссуться на коврик😒

Thank you

Excellent video, great instructions. Thanks very much!

Great insight. Had this issue today. Did you ever get around to filming the brake and rotor job you mentioned to me at cars and coffee about a year ago? Again I appreciate your DIY videos for the cayenne diesel.

Thanks 😊

thank you!

Thanks for the informative video. I have the same problem as well. What would happen if the floorboard stays wet for a week? Will it harm any modules? Thanks in advance .