DIY Homemade 1 inch Body Lift Hummer H3 

Thx for the comments! Yeah, this isn't really hard to do and it was fun!

No sorry I'm afraid not.... Mind you, it's pretty simple. Just crank the torsion key bolts in the front end will raise up. Pretty straightforward.

*barely* Not recommended to go beyond an inch and a half. Besides, anything more starts to look terrible too, as there's big gaps between bumpers and panels.

Nope, it made no difference whatsoever

I'm sorry but I don't understand your question. Can you elaborate?

@@edsgarage2.0 ah sorry sir , i mean i bought 5 cm ( 2 inc) plastic tubes than When i put it , front bumper have Space between car shassis how can i fix that ?

@@mirzagoksoy981 oh I see.... How high did you lift it? I only lifted the body 1" so while there's a gap, it's not that noticeable. The only way to fix the gap is to relocate the bumper higher.... I have no idea off the top of my head how to do that the best way, because I didn't need to. Sorry I can't be more help

That would require extensions for your steering column, and shifter. Plus it would likely stretch some wiring. Also, it would look terrible around the bumpers with giant gaps I think the max you would wanna go is 2"

Thx for the comment!

Uhh yeah that's RU-vid... I have zero control over that. But thanks for coming out.

Thx!

I bought them online... But I'm sorry that was a while back and I can't recall where from

It has a compression rating of 12000 pounds per square inch. It's actually the same stuff the store bought kits are made of. So far, zero problems

I got the bolts at my local auto parts place. And I got the plastic from a company here that stocks all sorts of plastics. I just googled plastic suppliers in my area.