Homemade mini power supply, ideal for testing leds, motors and other electronics:
Dual Meter : bit.ly/2u6Uykx
or bit.ly/2T8ItVK
DC module : goo.gl/XPGaXg
or goo.gl/ZsEU1N
4mm jack : goo.gl/93L5mm
10k Potentiometer : goo.gl/6FzL4X
or goo.gl/uqZDMe
or
10k precision potentiometer: goo.gl/oq6SrG
or goo.gl/SyZ4Qo
Multi charger goo.gl/RzrCf8
or bit.ly/2GIQ09Z
- Schematic at 2:29
1º-Power the DC Step-Down module using a transformer from 4 to 30 volt, conect the amp meter to the source "in"
2º-The yellow wire is pluged to the "out" positive side of the buck converter
3º-The remaining bigger black wire is conected to the "out" negative side, the the red is the output negative
Instructions :www.instructables.com/id/Mini...
Specs :
- Input: DC 3 - 40V (input voltage must be higher than the output voltage to 1.5v above can not boost)
- Output: DC 1.5 - 35V (continuously adjustable)
- Current: 3A (Max.)
- Built-in SANYO fixed capacitor
Specification Supply voltage: 4.5~30V; Measuring current: 10A
Features Dual-display digital current and voltage meter
Application With five wiring, easy to access to car / battery car / motorcycle car lines, used to monitor the battery voltage, battery voltage status grasp, can also be used for other products voltage and current measurement purposes
Other Supply voltage: 4.5~30V; Test voltage: 0~100V
Dual display digital current and voltage meter Ammeters set up. DIY How to make how to use lcd volt and amp meter Dual Digital
LM2596 DC to DC Step - Down Transformer Module Power Buck Converter Voltage Regulator Board
Adjustable Super Mini DC Power Supply for Arduino DIY Components
LM2596S DC-DC Step Down Power Module 2A Adjustable Buck Module Super LM2576
How to wire and build your Current / Voltage Meter with schematic
Adjustable variable voltage power supply
Make your own Bench Lab Power Supply project Workshop tool, Start to finish full video
#DTekDIY
14 фев 2018
