DIY Under Stairs Storage Drawers 

Haha nice one dude 🙌. Thanks for the Sub and comment 😀

Thanks Paul 💪

Thank you very much 🙌

Hey thanks for watching, good luck with your build :)

I’ve been waiting for this comment 😂

@@InDadsGarage 😆😆😆😆

Hey thanks for watching, and no such thing as a silly question in my eyes. So my stair case runs roughly at a 45o angle (some may vary). I just cut my end panel angle at 45o the glued and nailed it. Being honest it didn’t match the inside angle perfectly, however it was all covered with the trim so didn’t matter to much. The drawer fronts then line up to the true angle as shown with the laser lever. You could use a laser lever to start with and get it spot on, or a sliding bevel angle tool. Hope that helps

Also, be careful using the nailer, because the nails can move left/right, and, if your fingers are near the nailing gun, the nail can go through your fingers.. Though, good video!

Hey thanks for the sub and comments, haha you are right, its currently full of plaster dust and sawdust from my current build.

Kicks like a mule ;0)

Hey thanks for watching, drawer widths in the end were: 64cm 54cm 39cm (blanking pannel) Depth of drawers were 70cm Top tip don't build it outside without checking you can get it back inside first lol!!!

Hey thank you very much. In the ends I pinned them in place with the nail gun while they were all lined up and then put screws in from behind. Abit of wood filler and paint sorted out the nail marks in the front 👌. Thanks for watching and taking the time to comment.

Thank you very much 🙌. Due to the weight of them they are pretty much free standing. I did put a couple of screw up into stair case but it didn’t even really need that once it was all boxed in. Thanks for watching.

@@InDadsGarage fab! Thanks for replying. Keep the videos coming

Hi thanks for you comments and feedback. So far I have found the 12mm fine for the drawer construction however if I was to do it again I would use 18mm for the drawer fronts and account for that in the overall depth. The glue and nails have been plenty strong enough though for the construction and once in place and fitted under the stairs its solid but screw would work well too. Great point about the PPF and MDF dust, unfortunately as DIYers this kind of thing is often overlooked especially when only doing odd jobs here and there, rather than working with it everyday. Thanks for watching and good luck with your project :)

Hey thanks for watching, I used pretty much every Dewalt cordless tool I own: Circular Saw Jigsaw Multitool Impact Driver Drill Grinder also Nail Gun Circular Chop Saw Hammer Chisel Screwdriver Handsaw Tape Measure Penis Clamps Spirit Level Hacksaw Pri-tool (crowbar) Set Square Stanley knife ..... And probably a few more tools...

Thank you, great video, It helped me alot in doing my own under stairs storage....you have simplified this so I used it as a guide. Thanks.

Haha, I am basically Barry & Paul combined at times lol.

Hi thanks for you kind feedback, actually I didn't seal the inside but that's a great point and something I overlooked. Fortunately I am very OCD so only clean shoes go back in there lol. A little finishing off job for another time though :). Thanks for watching.