DIY VIPER CUT | FRONTIER - NAVARA - PATHFINDER 2nd Gen  

Many thanks for your comment!

BIG thanks! And glad it’s helped 👍

Thanks for your comment, glad this has helped!

Thanks very much for your comment! Once you've made your cuts to the bumper, unbolt and unscrew any parts attached underneath. Then pull the liner up towards the new cut angles, mark where they meet and trim off excess. To hold the liner in place I drilled holes where possible on liner and bumper and cable tied. Hope this helps bro!

Really appreciate your comment! I've seen some nice window cleaning truck setups online. I have a few mods I've done myself, which I hope to share on the channel soon!

@@BeeLeafInNature Many thanks for your kind comment!

@@StevenWashington-x7q Wow and BIG thanks for your great comment Steven, really glad you think so and glad I could help!! Sure thing, I switched the originals out, for a 2 in 1 LED Fog/DRL it’s the Type 2 - for Nissan Navara D40. Purchased from powerfuluk.com RU-vid.com/@L663 these guys do some great 4X4 gear 😎

Appreciate your comment! Thank you

@@MaxAnderson-x1t BIG thanks, glad the videos been helpful!!

Thanks for your support Adam 🫡

BIG thanks for your supportive comment! Much appreciated… Leave the liner until you’ve completely finished viper cuts. When matching liner to new bumper lines, pull it up towards that cut edge and mark where it meets. Then cut off excess. Try not to cut liner short, so as to fall behind the new edge, as you need the liner to slightly wedge against the bumper to hold well. Leave the lower part of liner, as this will give you some options for securing it to the lower front end of bumper with cable ties. Cut anything else off you feel is untidy. Also if you can zoom in on video at 2:20 you’ll notice I’ve drilled some small holes a few mm in from the edge of liner and looped cable ties through. I found a couple of spaces behind liner to secure these also. You won’t need to heat the liner with a gun, as it will be easy enough to pull into position. Buy some tough, extra long cable ties, so you can reach whatever secure points are available on bumper. Your rig will be stand out, and I wish you all the best with your mod 🫡

@@The4x4WindowCleanerGREAT JOB on your truck, this is very helpful…thanks for sharing!

@@MattPeters-t7v Appreciate your comment Matt and also your Sub, thank you 😁 Yes wheels are original stock, which I sprayed black and 2K satin lacquered. Also hand-painted Nissan logo centre cap in red.