DOVETAIL CUTTER - EASY 

Nicely done with a minimum of high accuracy tooling, good "seat of the pants engineering", something I've seen used around the world "to get things done" as needed. Thanks!

A VERY USEFUL CUTTER. AND IT'S HOMEMADE, TOO!

Great video, everything came out well. Thanks for the close up shots of everything. By the way, we can see the stiffness of the vertical column is a bit low, makes me wonder.

Браво маэстро! Супер!

Great video, i made a similar cutter to remake the top piece of an existing dovetail slide. The part I don't understand is how you accurately grind the cutter angle so the part being made would fit any manufactured dovetail rail. I'm remaking a carraige for an existing male dovetail rail and found out it needs to be a lot more accurate than a lathe compound rest can provide. I'm out less than a 1/4 degree and trying to achieve final fit by hand scraping was an exercise in frustration. I ended up spending the $80 on a carbide dovetail cutter to keep myself from going crazy.

Your idea is brilliant and also how it was done. Congratulations. It was just the tool I needed. Thanks so much for sharing.

Ferramenta eficiente, simples e de baixo custo.

Very nice. And this would be very expensive to buy in USA if you could even find anything similar. I see that your toolbit appears to be ground with enough relief on the heel of the tool. To anybody without much experience I want you to be aware so the heel of the bit has adequate clearance. Thanks for sharing and greetings from USA!

excellent design and looks to work great. Thanks for sharing your knowledge with others, very helpful!!

Muchas gracias maestro por brindarnos sus conocimientos 👍

Good job mr. I will make this tool to. Thankyou for sharing

Hola muy bueno el video. El torno lo hiciste tambien? Saludos desde Argentina

świetna robota 👍👍

¡Buen trabajo y buen idea alomejor voy a hacer uno manana!

Excelente amigo. Gracias por compartir

Show de bola mesmo hein laik grande tmjs

Bravo Turkey İzmir selâm 👍

Excelente idea!!! Si duda la copiaré, los cortadores son muy caros y se parten fácilmente, saludos desde México maestro.

5:40 I hear and feel vibration. Have you measured the runout and other things like bending the mill parts or its head ? Something feels like it's not sturdy enough. Or doesn't have enough weight

Good work

Nice post

Esa herramienta golpea demasiado, lo ideal que tenga varios filos😊

Excellent 👍

not bad, but it should also have an edge on the bottom side or at least be completely flush with the holder, otherwise the tool will always end up rubbing the piece you are cutting

Nice video, thanks :)

Super pomysł 👍👍👍👏🇵🇱

Good job 👍

Menarik

Muito bom 👍👍👍

Nice design

Excelente

Классно получилось! А если использовать треугольные сменные пластины 16мм? 🤔

Muito bom.

👍👍😎

Thankyou ❤

Keen job of making the tool but you didn’t dial in the angle on the cutter. The next piece you make after you hand sharpen the bit won’t make a part that will fit any previous parts.

hi, please can any one tell me the type of jaw chuck initially used on the clip

Для цветных металлов вполне пригодная штуковина! Хотя...

At 1:55 you use a center ruler tool. How is it called and where did you get it from?

so why did you make a conic tool if you could simply rotate the insert 45 or 60 degree? waste of time

Барахло. Точность как на глаз ножовкой.