Dynamic balancing rotor & impeller of 250HP motor | Level G1.0

Подписаться 725

Просмотров 26 тыс.

50% 1

Dynamic balancing rotor & impeller of 250HP motor | Level G1.0
Dynamic balancing definition: “Dynamic balancing is a way of balancing machines by rotating parts quickly and measuring the imbalance using electronic equipment. The imbalance measured can then be corrected by adding or subtracting weight from the rotating parts until the vibration is reduced.”
Thank to the team of Magneto Electric

Наука

Опубликовано:

28 фев 2021

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 15

@twintwo1429 2 года назад

Was the overhung impeller already balanced or taken into consideration?

@ontarioelectricmotorman7309 2 года назад

For this case, we balanced the impeller first because it was too much out of balance. We made a new shaft for the impeller balancing, after that we put the impeller on the rotor and balance again. In most of the cases, you can balance them together.

@twintwo1429 2 года назад

@@ontarioelectricmotorman7309 good practices. In our shop, we found that up to 20% of new impellers are not balanced to G-1 SPECS. same for various other attachments also. We had a customer complain of excessive vibration in a hazelton pump we rebuilt, less impeller. They installed a worn impeller with improper gap at wear ring. Go figure!!!.

@ontarioelectricmotorman7309 2 года назад

@@twintwo1429 yes, we would need the impeller, pulley or coupling sent in with the motor, unless it is a small unit.

@twintwo1429 2 года назад

@@ontarioelectricmotorman7309 👍

@alexandergarcia381 2 года назад

Saludos, como saber a cuantas RPM debo ajustar la realizacion de las diferentes pruebas en funcion del rotor, existe algo de guia? De antemano gracias.

@ontarioelectricmotorman7309 2 года назад

Por lo general, la máquina equilibradora recomienda la velocidad de equilibrado al menos 1/3 de la velocidad de funcionamiento. Por ejemplo, la velocidad nominal del motor es de 3600 rpm, elegiría 1200 rpm para la velocidad de equilibrio. Sin embargo, cuanto mayor sea la velocidad que elija, mejor, pero no menor que 1/3.

@alexandergarcia381 2 года назад

@@ontarioelectricmotorman7309 Excelente! Realmente agradecido!

@alexandergarcia381 2 года назад

Es decir que para un motor de 1200 RPM, con 400 rpm alcanzaría o sería muy pocas RPM para balancear en este tipo de máquinas balanceadoras.?

@ontarioelectricmotorman7309 2 года назад

@@alexandergarcia381 Sí, tiene usted razón.