Earmor M32H FAST Helmet Headset Installation Guide 

One thing to consider when wearing cold weather gear with a helmet is the seal of your ear-pro. I have permanent hearing loss in both ears from years of combat. Although I always did everything I could to protect my hearing, the cumulative effects of extremely loud noises will take its toll on anyone in this line of work. Whether you wear a fleece cap under your helmet or an integrated cold weather liner, you are placing a layer of material between your ears and the ear cups of your headset or ear-pro. This will reduce the factory NRR (Noise Reduction Rating) of the device and expose your ears to damaging decibel levels. In these circumstances it is important to double up your hearing protection by using in-ear buds (such as foamies or pass-throughs like the SureFire Sonic Defenders), or integrated hearing systems like the Ops-Core AMP with NFMI ear buds. Doing so will ensure you maintain the highest level of hearing protection while staying warm on the battlefield.

TO EVERY ONE HAVING THE SAME PROBLEM GETTING IT ON THE RAIL I HAVE FOUND A SOLUTION,where the philips head screw is on the mounting part of the headset is undo it and the mounting part separates into 3 pieces, take the piece that actually mounts to the rail spray some lubricant on it and the rail then gently tap it down the rail with a mallet (not a hammer) get them both in the same spot on eather side then put the other parts back on and screw it together again done. Takes 5 minutes

Hello, the colore of the headset in the video is TAN or COYOTE?

I bought a pair from you guys and I sure as heck don't have a tab like yours to move them along the rail. Hard as heck to get past the first slot. Came in from the backside and still not easy to move. Make a video on moving the mic from one side to the other. Can't get the tab to budge on that either. Beginning to think this is junk.

I have this mask that goes on the arc rail barely works with these is the TMC half mask, There’s enough room on the ark rails for both but you have to screw around with it to get both to work. If there was more room on the ark rails this wouldn’t be a problem.

I have the issue of my arc brackets not being tight enough, can’t get a good seal at all

Having issues with these fitting on my ears

Mine didn't have nice big tabs. I got these little nubs that feel like I'll break if I put any pressure on them with a tool. Left went on okay, right is stuck and is currently rendering my helmet useless. Thanks.

Cool but funny how he doesn’t provide information about if it’s a MOD1,2, or MOD3 because I own the M31 MOD3s and planning to get their arc rail adaptors.

Bought this exact same product and the rail adapter does not move past the first notch. Does it only take specific helmets?

How do you even instal the arc adapter to the headset? Feels like i rip the headset apart removing the irons.

Just bought a pair of these today and I don’t have the tabs that adjust the headset. Also when I try to install it to the rails it gets stuck in the first position and can’t go any further. It was also very hard to take it back out cause it was stuck pretty good

Please do a tutorial for the MOD 3.

Mine keeps popping out from the rail every time I try to put it on. It's frustrating.

Do you have a suggested radio

Good headset, but be warned you need some adjustments so that you can wear them on a FAST helmet otherwise they will be too tight.

I have a question the headset doesn't sit tightly on my ears it hovers above my ears anyone have a tip about this how to get it tightly on the ear

How do you actually put the headphones onto the adapters

How do i tighten their pressure when clicked inward to ears ?

anyone else have a problem where the microphone gets in the place of your guns?

What helmet is used in this video?

Can I pop the ear cups out and install my own arc rail adapters?

Say you were running the 6mmproshop face mask mounted to the arc rails, would you be able to use the railmounts for the Ear pro? Is there a way to bend it and fit it on the back rails?

Bosen ah ora ono penjelasan sing genah

How do I get the ptt for this headset?

Can i use it for gaming or phone music listening?

Do they make them in bluetooth?

Berapa harga dan kemana yg mudah mendapatkannya

Jack type?

nice

This is hard idk if I’m doing it right lol

I dont have those flips wtf

Dope ✌️