Easiest Method Carpenters Use To Layout And Install Stair Skirt Boards - Finishing Trim Examples 

Thanks for this information it’s helpful

Thank you for all the time and effort you put into all your videos. They are very helpful and informative.

OMG muchas gracias for all the time and details it’s very helpful, l do appreciate it 💞

I hope this is for remodels. If you’re stuck with this method in new construction, then the contractor messed up. The REAL easiest method is to space the stringers off of the framed wall with a 2x. This leaves room for the drywall and skirt board to be installed with no notches other than top and bottom. Then treads or carpet can be installed to cover the remaining 1/8 to 1/4quarter inch gap.

How would you go about layout for a stair case that doesn't have 90 degrees steps. If the risers has a back cut for instances. So the treads are level with the floor, but the risers aren't. So the tread could be at an 80 degrees angle for example to allow for more purches on the tread.

How do you make it look like one board?

Is it recommend to cut the first notch out at the floor level, then slide the skirt onto the floor, then mark out your treads and risers?

Do you have a video that explains how to do this with a rounded edge step?

If we have notches on the stairs, how do we measure for that?

I have a 90° staircase (4 steps creating 90° to the straight run above) that I'd like to add a skirt to. Trouble is that when I lay the 1x12 in position for marking, the two bottom steps sit about 2 inches below the positioned skirt board. The 2 angled steps that create the 90° staircase sit level with the board and seem easy to mark. Is there a way to make the bottom 2 steps work for skirting?

My one is different how i can cut it ?

where are the videos for this if the steps are all different?

Waiting for that video where the board doesn’t rest on all the treads