Yes I use the words forces and pressures rather than saying backlash to explain that and I probably should have said it is the same thing. I appreciate the feedback on these.
Thank you, as someone new to CNC I wasnt sure why Carveco defaulted for climb cutting as ive spent all of my woodworking life doing the opposite. This explained it perfectly and quickly!
I have been a subscriber for a while, never got notices about new videos. Failed to hit the notification bell. Corrected that, now I will get all your videos.
Yes but the toolpath can go either direction and is why you would pick climb vs conventional. This is confusing because the bit turns the same direction on the inside of a vector as the outside but because it is a different side of the bit cutting it requires different directions depending on what side of the line you are cutting. So you would need to pick the correct direction to get a climb or conventional cut to have the chips cut evacuate in the right direction. Hope this helps
For most situation I would agree. There are a few situations where conventional will give a better finish. I go over that towards the end of that one. Thanks for watching and the responses.