I tried to make a motor break-in method into a video. But this is not the correct answer. I think the way of thinking is important. 【ミニ四駆】モーター慣らし カーボンブラシ編 • 【ミニ四駆】モーター慣らし カーボンブラシ編
During the 8hours continous break in do you need to re oil or just the oil in the beginning is enough? Is vodoo oil a good oil to put in the commutator before the break in process? Thank you :)
thanks for sharing your experience. I have an adjustable power supplier but no cooling system. I run a Hyper Dash Pro at 1.5v for 15,000,000 rotations (about 16 hours). The improvement was from 27,000 rpm to 28,000 rpm which was not as huge as your job. Was there anything wrong?
There are Hit or miss in the motor. In the case of HDP, 3V, 30000rpm at the time of opening, I think it is "Hit Motor". However, the 27,000 rpm motor is at a normal level, but if you break in, it will rotate about 30,000 rpm. ・Did you lubricate the motor shaft? ・Do you have a contact restorer? Lubricate the shaft before break-in and use contact restorer after break-in.
I had problems whit my Motor it was stuttering a lot I bought these 3 layer carbon brushes do I need to run them in for a very long time to make good contact?